Pyramid DC Receiver Manual de Instalação descarregar pdf (Página 15)

Page 15

Installation Manual Pyramid DC Receiver

ADDRESSING A RECEIVER WITH THE MK1 KEYBOARD

A receiver can also be addressed using the Pyramid Mk1 Keyboard. Follow the steps below:

1. Connect up a Pyramid Mk 1 Keyboard to the telemetry receiver. This can either be connected directly to the receive

communications card at the receiver site, or remotely through the Pyramid network in the normal way.

2. Using the keyboard, insert the Installers Card and log on with the PIN number 1892.

3. Press the key sequence 100 and then the Function key.

The left hand side of the keyboard display will show Fn 0100 to indicate that self binding mode has been invoked.

4. Repeatedly press the List Down key, until the LCD display shows the option Replace RX.

5. Once this option is displayed, select soft key number 1 marked Yes.

At this point, the keyboard is now waiting for the receiver to identify itself using the service PIN.

6. Momentarily short out the service PIN jumper on the receiver PCB (see figure 2).

The receiver neuron ID is transmitted onto the network, and the keyboard display will show the text Receiver Identified.

7. Type in the node ID you require this receiver to be configured to, and then press the Camera Select key.

After a short delay, the keyboard will then display the message Subnet Node Calculated.

8. After 10 seconds, the keyboard will then log itself out automatically.

9. Repeat steps 1-3 to log back on to the keyboard and go into self-bind mode.

10. Select a camera in the normal way by typing in the node ID and then pressing the Camera Select key.

11. Move the joystick. The PTZ will move, and the standard receiver screen will be displayed on the keyboard.

Troubleshooting

Q I pressed the service PIN on the receiver, but the keyboard did not show the Receiver Identified message.

A No data is coming through, check out the data cabling between the receiver and the keyboard.

Q I got to stage 7, but the Subnet Node Calculated message remained on the keyboard screen and the keyboard did not

log off.

A Data is only being transmitted in one direction. Check to see if the data cable has been connected to the correct side

of the communications card, or that one side of the twisted pair has become disconnected.

Note

The DC receiver can also be addressed and installed using the Pyramid Installation Tool. See the Pyramid Installation

Tool Operating Manual for more details.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

Pyramid DC Receiver Manual de Instalação Página 15